城市污水生物脱氮除磷机理研究进展

介绍了生物脱氮、除磷的基本原理，综述了国内上关于城市污水脱氮除磷机理方面的研究现状和进展，并对今后开展这方面的研究提出展望 。     

壬基酚聚氧乙烯醚在污水处理过程中的迁移转化行为

用正相色谱－质谱联用法（NPLC－MS）分离分析高聚合度的NPnEO(n＞2）,用气相色谱－质谱联用方法（GC－MS）测定其中的NP,NP1EO和NP2EO浓度,对NPnEO在城市污水处理厂的迁移转化行为进行了研究。在污水处理厂的进水中,检测出NP和NPnEO(n=1-23）,总浓度为174nmol/L,其中NP2EO的浓度最高,为89．6nmol/L;其次分别为NP（42．2nmol/L）和NP1EO（12．2nmol/L）;出水中同样检测出NP和NPnEO(n=1-18),其中NP2EO的浓度最高,为37．2nmol/L;其次分别为NP（6．64nmol/L）和NP1EO（0．135nmol/L)。在城市污水处理过程中,NPnEO从高聚合度降妥成低聚合度,NP和NPnEO的总去降率为71％。另外,NP和NPnEO在污泥及污泥过滤水中的分配表明污泥对NPnEO有明显的吸附作用,并近似符合Dubinin-Astakhov等温吸附。     

Effectiveness evaluation of water-sprinkling in controlling urban fugitive road dust based on TRAKER method: A case study in Baoding, China

Fugitive road dust (FRD) contributes a great deal to urban rainwater and air pollution and is commonly controlled by water-sprinkling in most Chinese cities. However, there is a lack of information on its effectiveness. We used the Testing Re-entrained Aerosol Kinetic Emissions from Roads (TRAKER) method to monitor different types of roads in Baoding city before and within 1 hr after water-sprinkling and obtained the road dirtiness index (a) and PM concentration in the road environment ($T_{\mathrm{T}}^{*}$), to evaluate the removal efficiency for PM deposited on the road surface (${\eta }_a$) and the reduction efficiency for the PM concentration in the road environment (${\eta }_{\text{PM}}$). The results give that the ${\eta }_a$ for three types of roads is ranked: branch road (87%-–100%) > major arterial road (80%-83%) > minor arterial road (68%-77%), and the ${\eta }_{\text{PM}}$ ranked: minor arterial road (70%) > branch road (46%-58%) > major arterial road (37%-53%). The ${\eta }_a$ and ${\eta }_{\text{PM}}$ varied non-linearly with time and presented a quadratic curve. The average effective control time (${\eta }_{\mathit{a}}$> 0) was 62 min on the major and minor arterial roads, and much longer than 1 hr on branch roads. The ${\eta }_{\text{PM}}$ values diminished completely by 72 min on average from the end of sprinkling for the three types of roads. Water-sprinkling can remove PM₁₀ particles from the road surface and reduce their concentration in the road environment more thoroughly than PM_2.5. Our findings could be helpful for controlling urban FRD emissions more efficiently and precisely.     

铜的大气腐蚀研究

综述了各种因素对铜大气腐蚀的影响,其中介绍了单一气体SO2、NOx、O3及混合气体协同作用对铜大气腐蚀的影响。在铜腐蚀中,SO2 NO2的协同效应只有在一个相对高的湿度(90%)下才发生。SO2 O3的协同效应要强于SO2 NO2的协同效应,这可以解释为什么铜在富含O3的乡村环境中有高的腐蚀率。重点阐述了硫酸铵微粒的影响,在硫酸铵的临界相对湿度(CRH)时,铜的腐蚀率和机制变化很显著;同时介绍了铜的几种腐蚀产物及其形成机制。简述了研究铜大气腐蚀的常用实验方法和几种表征手段,并展望了铜大气腐蚀的研究趋势。     

城市污水高效低耗生物脱氮工艺研究

采用活性污泥与生物膜法相结合工艺处理城市生活污水，可以高效去除污水中的有机物和NH4^ -N。研究结果表明：水力停留时间为7．5h、回流比为1．5、无外加碳源时，COD的去除率大于90％，NH4^ -N的去除率大于99％；平均出水COD小于40mg／L，NH4^ -N小于1mg／L，TN的去除率60％左右；反硝化过程的适宜C／N为4～5。     

ABR工艺预处理木薯酒糟废水的工程应用

木薯酒糟废水有机物浓度高、悬浮物含量大、pH呈酸性、可生化性能较差 ,通常直接采用固液分离—厌氧 (UASB)—好氧曝气生化法处理效果并不理想 ,而采用ABR工艺进行厌氧水解酸化预处理木薯酒糟废水迄今为止未见报道。经绵阳市酒厂废水治理工程证明 ,强化ABR预处理工序是保证后续处理措施能否正常运行的关键     

影响微生物絮凝剂产生的因素研究

本文通过改变培养基的种类、培养基的碳源、氮源、无机盐离子来选择絮凝剂产生菌“Dfjm-1”高效低廉的培养基 ;通过改变培养基初始 p H值、培养温度、培养过程中的通气量等因素 ,得出“Dfjm-1”菌株产生絮凝剂的最佳条件。Dfjm-1产生絮凝剂的最佳因素为 :培养基初始 p H值为 6.5～ 7.0 ,培养温度为 3 0℃ ,培养时间为 60小时左右 ,通气量为 :早期 :2 50 r/ min;中期 1 50 r/ min;后期 1 0 0～ 1 50 r/ min     

小诺霉素发酵废水好氧生物处理试验研究

对具有强抑制性污染物的抗生素小诺霉素发酵废水，选择活性污泥、粉末活性炭（ＰＡＣＴ）、纯氧曝气等３种好氧生物处理法进行了比较试验。根据实验结果，小诺霉素发酵废水的生物降解呈抑制动力学，采用Ｍａｒｑｕａｒｔ方法对动力学模式进行参数估计。ＰＡＣＴ能够有效地降低降解过程中微生物受到的抑制作用，从而明显地改善了生物处理过程动力学。     

Characteristics of phosphorus chemistry and its geographical distribution in the Haihe River valley,North China

ＣｈａｒａｃｔｅｒｉｓｔｉｃｓｏｆｐｈｏｓｐｈｏｒｕｓｃｈｅｍｉｓｔｒｙａｎｄｉｔｓｇｅｏｇｒａｐｈｉｃａｌｄｉｓｔｒｉｂｕｔｉｏｎｉｎｔｈｅＨａｉｈｅＲｉｖｅｒｖａｌｌｅｙ，ＮｏｒｔｈＣｈｉｎａＪｉａｎｇＧａｏｍｉｎｇ；ＨｕａｎｇＹｉｎｘｉａｏ；Ｌ...     

Yellow River Valley flood and drought disaster:spatial-temporal distribution predictionand early-warning

ＹｅｌｌｏｗＲｉｖｅｒＶａｌｌｅｙｆｌｏｏｄａｎｄｄｒｏｕｇｈｔｄｉｓａｓｔｅｒ：ｓｐａｔｉａｌ－ｔｅｍｐｏｒａｌｄｉｓｔｒｉｂｕｔｉｏｎｐｒｅｄｉｃｔｉｏｎａｎｄｅａｒｌｙ－ｗａｒｎｉｎｇＧａｏＬｉｎ，ＳｈａＷａｎｙｉｎｇ，ＬｉｕＨｕａｉｑｕａｎ，...